Opens in a new tab
EN-US
Generator Guides

Generator Voltage Fluctuation: Information to Gather

Technician checking a generator control panel with diagnostic equipment

When generator voltage appears unstable, useful records can shorten the investigation. Begin by describing the event and the connected load. A changing display does not establish an AVR fault, and a problem at one circuit may differ from a problem at the generator output.

Describe the voltage behaviour

Record whether voltage dips briefly when equipment starts, repeatedly rises and falls, or remains outside the expected range. Note the duration, time and any affected equipment. Save photographs of accessible display readings and exact alarm messages.

Include the displayed frequency. Voltage and frequency changing together can give a technician different information from a voltage-only event. Also note whether the behaviour is new or has existed since commissioning.

Link the event to the load

List equipment that started, stopped or changed operating mode at that moment. Identify large motors, welders, UPS equipment and variable-speed drives. Include recent changes to the installation, load sequence or controller configuration.

For example, a voltage dip coinciding with an air compressor restart should be recorded with the compressor’s identification and starting method. That does not prove the compressor or generator is faulty; it identifies an operating condition for review.

Industrial conveyor motor and drive equipment

Keep measurement conditions clear

Tell the technician where each existing reading came from: the generator controller, a transfer panel or a load-side instrument. Specify whether it describes line-to-line or line-to-neutral voltage where known. Differences between measurement locations can be important.

  • Generator, engine, alternator and controller models.
  • Voltage, frequency and load readings with timestamps.
  • Alarms and recent maintenance records.
  • Connected-load details and operating sequence.
  • Any earlier commissioning or test results.

Measurements requiring access to electrical terminals or panels should be performed by qualified personnel with appropriate equipment and the relevant procedures.

Arrange a model-specific assessment

A technician may need to assess load balance, sensing circuits, excitation, engine speed behaviour and the distribution installation. The correct checks depend on the identified equipment and symptoms. Do not adjust the AVR, bypass protection or replace parts simply to see whether the reading changes.

See NPC generator sets and send NPC the model and event records when requesting technical information. A clear record helps direct the enquiry to the appropriate equipment guidance.

All Generator Guides